[quote=SwampCollie;3401079]Hey I respect your opinion as much or more than anyone's dry... just like customers callin' on the phone... its dang hard to diagnose anything you don't have in your hands.
WMD:
Absolutely take what DR wrote seriously. He knows his stuff and has been doing this WAY before I was even a twinkle in my daddy's eye.
My only other question is.... you say when you index odd vane up.... that you have a vane 'basically' touching your closest cable..... is it actually touching or hitting? Or does it look like its going to when you eyeball it?
It is not touching but I dont have enough room to slide a paper towel through what gap is there.
One other little thing to try too that I've found has worked often with the Hunter models (that are prone to bounceback)... trying sliding the whole rest forward about 1/4" or so. I can see you have it set back just a bit... so you have some wiggle room. Slide it foward until you can just fit a credit card between it and the riser shelf. Just loosen the berger and set screws... slide it up and re-tighten, making sure the works are still level.
I will try this after I re-check and make sure my left/right is good and see if I still need to move my nock high a little more?!?
Thanks