HuntingNet.com Forums - View Single Post - Torn between 2 arrows( Axis and ICS)
View Single Post
Old 09-11-2008 | 12:56 AM
  #12  
OHbowhntr's Avatar
OHbowhntr
Nontypical Buck
 
Joined: Feb 2007
Posts: 2,531
Likes: 0
From: SE Ohio
Default RE: Torn between 2 arrows( Axis and ICS)

ORIGINAL: Crazyfarmer

guys, i measured my draw with the 32inch arrow on and its 27 right to the rest. Would 28 be to short? Or should I go 28.5 atleast in length
If you like the ICS Hunter with a .003 straightness, these are NICE...... http://www.cabelas.com/link-12/pod/0004537.shtml .......and the price is right. Raw shafts for $52/dozen, fletched for a little more. I've RH'd many of these, and they are better than MOST arrows out there you'll find. If you call a Cabela's store, you can get them cut to length, and shipped to your door for under $60/dozen, or at least that's what I'm usually getting them for.

If you go with a 28" arrow, which should be fine, and put a 125gr tip on it, you'd be just about as close to PERFECT as you could get for SPINE according to OT2, and maintain an FOC of 12.6%, which should equal GOOD arrow flight.
OHbowhntr is offline  
Reply