ORIGINAL: HEAD0001
ORIGINAL: Rifle Loony
Slugging a barrel and sizing accordingly yeilds a correct GC fit.
I am not sure who the expert is here. But I do know that Slugging a barrel and sizing a bullet has nothing to do with the fit of GC's?? You seat(or fit) the GC before you size your bullet. Or at least while you are sizing your bullet. A lot of shooters use a GC and do not even size their bullet.
Slugging a barrel yeilds a measurementof diameter across the grooves, yes or no?
Obtaining a sizer/luber die that best represents the adequate fit per that dimension AND casting for a minimal required amount ofsizingsans excessive swaging of the bullet yeilds best fit/best accuracy upon sizing through said sizer/luber. Common sense dictates that the least amount of sizing yields best accuracy, yes?
Last I checked the CG's going through my sizer/luber went through the same die that the bullet goes through....thus yeilding same/samebest fit per bore dimensions.
No?
Ordo they magically stay bigger or something?
Gas checks in hot hardcast45LC loads are simple insurance against many evils......