ORIGINAL: pizzitem
Thanks Wilson
That is a really good site. What if I wanted to change my string and cables?
The specs for the 08 Guardian are 7 1/8 for the brace height and 33 3/4 for the axle to axle.
Iassume that I would twist the string and cables to make these things line up. How would I do that? Is there anything else that I would need done or could Ithen go to the tuning guide and follow the steps there?What about making sure the binary cams were lined up properly?
Thanks
Jeff
First, you need to see if the bow needs tuned. Is the ATA good? Are you reaching peak wieght? Do you get good tears thru paper? Does you BH's and field points hit same POI? have you drew the bow back and see if the cams stops hit the cables at exactly the same time?
What I did to learn was take an older PSE of mine and changed out the cables and string, took everything apart. And put it all back together and paper tuned it, then bareshafted, then BH tuned. I then played around with creep tuning.
I also saw the effects on tears by raising my nock point 1/2" too high and came down slowly and went past the point of bullet hole tears to see the different effects.