1. Make sure your modules are ALL seated and tight. For some reason this bow will kick mod screws loose pretty easily? If you have the right draw length mods in I suggest blue loc-tite for the mod screws.

2. Check your cam spacers top and bottom. An fairly early run of bows went out with an out of spec set of limb tip caps which caused a conflict with the correct diameter spacers.
There is nothing structurally or functionally wrong with these bows other than that limb cap needs a slightly thicker spacer to make up for the difference in specs.
In other words you could have a couple loose thin spacers on one side of your cam. This will be easy to visually check. If you can see axle showing through or can spin or move the spacers with your fingernail that's most likely where your noise is coming from. (Plink the cam edge with your finger and see if you can hear a buzz)
It would be a 5 minute fix for your dealer to set it up with the correct thickness spacer set.