Lets say your BH is supposed to be 7.5", and your at 7 5/8". Would you care? Or your .3" over your ATA? Where do you guys make your ATA measurements? from the middle of the axle to the middle of the other one? (Thats the way I do it.)

I generally never get worked up over 1/4" or less, until it affects my draw weight.

I was measuring my commadner this weekend, and it maxed out at 68#. used to be 70#. So looked at ATA and it was 37.5", and should be 37.25"(middle of axle to middle of axle) and BH was 7 5/8". Which doesn't make sense why I lost 2lbs, since longer ATA from string streatch would mean lower BH. Am I thinking right? I think I might tighten my cables a tad.