NO!

Not with Hodgdon 110.

They have a very specific warning about it:

For those loads listed where a starting load is not shown, start 10% below the suggested maximum load and then approach maximums carefully, watching for any sign of pressure (difficult extraction, cratered and flattened or blown primers, and unusual recoil). H110 and Winchester 296 loads should not be reduced more than 3%.
Reduce H110 and Winchester 296 loads 3% and work up from there. H110 and Winchester 296 if reduced too much will cause inconsistent ignition. In some cases it will lodge a bullet in the barrel, causing a hazardous situation (Barrel Obstruction). This may cause severe personal injury or death to users or bystanders. DO NOT REDUCE H110 LOADS BY MORE THAN 3%.


http://data.hodgdon.com/main_menu.asp


If you are looking for a light load, try a different powder.