Last night I was looking at my new Reflex Growler and measured the distance from the limb joint (where the limb and riser meet) to the string, both upper and lower. The lower limb measures just a little closer to the string - maybe the thickness of a dime. Both limbs are maxed out in terms of the riser bolts. Is this enough to be concerned? The bow shoots pretty well and paper tunes fine - even though the arrow is a little high on the Berger hole and the nocking point is right on perpendicular with the string/arrow shaft. I'm assuming the cure is to back out the riser bolt on the lower limb until the measurements are the same . . . .