Is there a reset button on the Moultrie I40??

I got a Moultrie I40 a couple of weeks ago, did theweb site downloads and built a security box (thanks to stainless, I will post pictures later).
Went to put it out yesterday and could not get the camera to go to "auto mode" even after letting the camera sit for 4 minutes as the directions statedthe camerawould automaticlly switch.

After bringing it back home, I discovered that the level 2 software was not updated.
Per the instructions, when I tried to clear the internal memory andformat the SD card the camera kept saying to redo.
When I tried to download the update, my computer would not recognize the camera but the camera could read the computer as the camera read USB active and the status light was on.

I then thought I could remove the batteries (overnight) and start all over. NOT.
All of my changes are still there.
Does anyone know of a reset button on this camera?

I have had success with Moultrie's service before, so I am going to call them tomorrow and see if no one here knows.
thanks