ORIGINAL: nysbowhunter
I have read a few posts here abount using a mizzy wheel to sharpen agate type flints (tc especially). I have looked all over for a "mizzy wheel". I believe they are an attachmentfor a dremel tool but nobody here has even heard of them. where can i get one as I have a pile on flints that need a new edge. also I am about out of 2f black but I have a whole can of 3f. I am going to drop my charge from 90 to 75 grains with the smaller powder I hope this is a good idea. I'm sure somebody has tried this, what was your experience?
This is far superior to a mizzy wheel...used them both...these diamond cutting wheels go through flint like butter...don't inhale the dust.
Dremel Diamond Cutter (grinding) wheel
Found them at WidgetSupply.com...They are in the category of burrs & cutters...not 'grinders' as I had always been searching.
http://www.widgetsupply.com/page/WS/PROD/dremel-diamond-wheel-1/BDL34