Also a couple of comments about the Lee anniversary components; if you all would like to know;

The "Perfect Powder measurer" is not really that perfect; it's close though. I weighed each charge on the Lee Safety Powder scale and found that I had to add or remove several grains 2 out of three times, to get to the desired weight. The measuring scale on the Perfect Powder Measurer is not accurate either, hence the need to weigh each powder charge with the scale. Hope the scale is accurate itself....

I had to grind away the openings on the Lee priming tool itself (where it holds the auto prime shell holder) so it would accept the 300 WSM case; the shell holder would fit the tool and accept the case, but the tool was not wide enough itself to accept the case.

The little powder funnel that cane with the kit spilled powder all over when attempting to use it with the 300 WSM shell, I ended up making a paper funnel to "funnel" the powder from the plastic funnel.

The little chamfer bit that is supposed to clean up the inside and tyhe outside of the shell after trimming and sizing works OK on the inside of the shell, but doesn't have the depth to reach the outside shell edges (due to the way that the 300 WSM shell is designed).

Every other component works satisfactorily; certainly a little yankee intervention and American ingenuity made the kit work.

Kindest regards,

-Will in Maryland