I got a couple of cheap plastic rods at Menards, kinda resemble re-rod but theyre green.Wrap the ends of the blind around these and hold em in place with plastic ties, youll have to make small slits in the grass to do this but theres a string that runs down the edges that should hold it together.Make sure you leave about 6 inches of the stake below the bottom of the blind to push into the ground.

Take a couple chunks of rope about 3 ft long or so and tie around the top of the stakes, on the other end of these I just tied a couple plastic tent stakes, youll need these if theres much wind to keep it from blowing around.

On mine I also had to cut a shooting hole through it due to my son being much shorter then I am.If your sitting on the ground its taller then a adult anyway so you may need one or you can just shoot around the edges.

For this I just took a tin snip after figuring out where to cut the hole and cut a slot out of the middle big enough to shoot through.On the back side of this I took some wire mesh, like chicken wire or something, and used more plastic ties to secure it over the hole and hold everything together.After its secure just cut the wire out around the hole with a tin snip.I used the strings that run through the blind for the most part to attach the mesh and if you use a light mesh it should roll right up when your done with it.

Wieghs a couple pounds at the most and the ropes on the outside also double as a binder to tie it together when your carrying it.