Callin 04 Patriot owners, what's your specs??
I’m in need of some quick specs. My bow is pulling 76# if I set it to factory specs of 33” ata , 7” brace and placing the cam timing marks at as close to .305” as I can get them.
A bowtech technical adviser told me to put the cam timing hole (not mark- the hole below the module) at half hole when compared to the limb, but this only made my poundage increase.
What I’m wondering is where is everyone else’s Patriot spec wise. ATA, Brace & cam rotation (on the mark, .305”?)
I stretched the ATA to 33 3/8” at 65# last fall so I could get through deer season without fooling with it. (This allowed me to lower my poundage to my desired 65# with 2 turns out of each limb bolt). Now that season is over I want it right 33” ata @ 70#.
I’d like to figure this out myself before I ship it back, but at this point I can’t see what I’m doing wrong. We tore it down at a pro-shop today to make sure it had the standard rockers in it & it did. The tech was at a loss in the matter.
I am running a floating Yoke, but can’t recall it increasing my draw weight when I put it on, does a floating yoke pick up the draw weight?
Any hints on what may be causing my poundage to go up so high?