Oh man....The old Glenfield 4x32 scope on my Marlin 30-30 lost its "zero" and won't hold true anymore. I guess it stems from huntingup in the mountains this past week and storing the rifle at the camp near the fireplace, then going outside at 18 degrees in the early morning and going hunting. I don't know.... maybe that had an affect...

Anyway, please look over the photo below of my target set at 50 yards. The numbers next to the bullet holes are the sequence of shots, along with my thoughts on the shot. The numbers in yellow are later on, after I asked advice at the range from another guy and suggested I pull the scope and use the open sights at 50 yards to see if it's the gun, the scope, or me. So, the numbers in yellow are the plain jane Marlin 30-30 at the bench rest with stock open sights.

1: Holy **** what happend to my scope?
2: There... 16 or so clicks up and a few clicks over. A touch high but not bad...
3: Holy **** now what happend? Why is the shot down there?
4: Way up high after adjusting the elevation again.
5: Not again!! WTF is going on?!?!! [:'(]
6, 7, 8: rapid fire shots with no adjustment to scope. I gave up! [:@]
***Pulled scope and base off right there at the table upon advice from another guy***
9, 10, 11, 12: Open sighted shots at 50 yards with stock sights at bench rest.

Question: Seeing this whole scenario, and the open sights shot pattern, would you buy a new scope for the 30-30, or just leave it open for short range deep woods shots?
Anyway, here is my beloved Marlin 30AS without a scope. I kind of like it like this... It's light, quick, real easy to carry, and now has a classic look.

So honestly... What would you do? Buy a new scope, or leave the 30-30 as is with open sights? I know I'm no "dead-eye Dick" or anything, but I was impressed with the shots at 50 yards with the stock open sights!

Butch A.