My elk and deer season opens saturday and my bow is in pieces!! I had it ready to hunt and my Ironhead 125 heads were flying like darts. Sunday I was practicing and my cam bushing failed causing my cam to hit my limb. I replaced the bushing but the cam is canted now. I stripped the bow down again and one of the limbs seems to have a different bend than the other three!! I borrowed another XT200limb off of my buddies 3d setup and put it back together last night. Now I am getting a tailrightpaper tare that I can't get rid of. Any suggestions? I tried breaking the bow down and swapping limbs side to side and then end to end but no help. Ihave tried shafts ranging from 400spine toa stiff 340 with no difference in tear. There is now way I can adjust my rest far enough to takecare of the poor tear. Could I have bent my riser? Ihave never had these kinds of problems so close to a hunting season. I am not going in the woods with my equipment not up to par.Anything like this happen to any of you?