HuntingNet.com Forums - Zwickey not straight?

HuntingNet.com Forums (https://www.huntingnet.com/forum/)

- Traditional Archery (https://www.huntingnet.com/forum/traditional-archery-19/)

- - Zwickey not straight? (https://www.huntingnet.com/forum/traditional-archery/76727-zwickey-not-straight.html)

hornbow

10-22-2004 10:37 AM

Zwickey not straight?

I bought a 6-pack of Zwickey broadheads and got some glue-in adapters so I could use my aluminum arrows.

I glued the adapters in with stick-tight and pressed the tip down into a 2x4 as hard as I could to seat them. All but one of them spin OK. One wobbles really bad. Is it possible the adapter was bent? Did I do this wrong?

Longbow Bowhunter

10-22-2004 11:35 AM

RE: Zwickey not straight?

Could be the adapter, but I find if you rotate the broadhead a little that should line it up.

Lilhunter

10-22-2004 08:11 PM

RE: Zwickey not straight?

my guess is you didnt get them warm enough, that glue sets up enough where it wont seat properly inside the bh ferrule. Dont burn the paint, but you need to get that hotmelt just about to the point it bubbles, just a tad cooler then that and its perfect. You'll feel the ferrule bottom out. If it doesnt its "floating" on the hot melt and wont seat right.

hornbow

10-26-2004 02:44 PM

RE: Zwickey not straight?

Tried heating it up and rotating the insert; no change. It still wobbles badly. I did burn the paint a little around the base of the broadhead. The good news is that is still flies OK. It grouped right along with the others that spun well. I guess I will just keep that one as a back up and use the others as my primary arrows.

hornbow

10-26-2004 02:49 PM

RE: Zwickey not straight?

I ran into another unexpected problem. I have the 4-blade ones with the little bleeder blades sticking out. The bleeder blades get in the way and make it difficult to get the correct angle on the sharpening stone. How do you sharpen these things? I ordered one of those carbide cutter sharpeners from Cabelas so I guess I will try that.

They are already pretty sharp but not shaving sharp like I want them.

Do you sharpen the bleeder blades too? They seem pretty dull....

Lilhunter

10-27-2004 12:10 AM

RE: Zwickey not straight?

there was a great thread on tradgang.com on how to sharpen zwickeys with bleeders. I'll see if I cant dig up the link

Lilhunter

10-27-2004 12:14 AM

RE: Zwickey not straight?

http://tradgang.com/cgi-bin/ultimate...c;f=2;t=000031

There ya go

hornbow

10-29-2004 11:53 AM

RE: Zwickey not straight?

Thanks. I bought an accusharp already and it did a good job on the main blades. Now, I need to get those bleeders.

All times are GMT -8. The time now is 09:24 PM.