Anyone using NAP Quick Spins and CE Terminator Hunters?
 

Just curious what type of glue you are using and if there is any special prep work need for the BuffTuff shafts.
Thanks

RE: Anyone using NAP Quick Spins and CE Terminator Hunters?
 

Joe,

I tried the Quickspins on my CE CX Hunters and used both Fletch-Tite Quick Gel and Super Glue Gel. Both worked fine and the fletching did not come off after several dozen shots. Only prep I did was to remove all the old glue with a razor blade. Be careful not to dig into the BuffTuff finish. Then I washed them off with soap and water and dried them.

On a side note, I was not impressed with the way the Quickspins worked. My arrows shoot very straight with the CE vanes but wobbled horribly with the Quickspins. Maybe it was just the way I put them on, dunno. I am going to try some of the Blazers next. I keep shooting my vanes up and people say they are so small that they don't get hit that often and they fly very well.

Steve

RE: Anyone using NAP Quick Spins and CE Terminator Hunters?
 

I shoot goldtips, so I dont know anything about the ce arrows. But I can tell you to save your money on the quick spins. I bought a dozen about a month ago, with 1/2 being regular vanes and the other 1/2 being quick spins. They both shoot just as tight out of my bow (@ 2" group @ 30 yds.) the only difference is that the qs's hit @ 1" higher @ 30 than the regular fletchings do, and make a hellacious whistling noise going downrange. Even with my loud*** bow you can hear them whistling bad. If I were you I'd get either vanes or feathers and leave the qs's alone.

RE: Anyone using NAP Quick Spins and CE Terminator Hunters?
 

I use the cx terminator shafts. Scrape the old stuff off and clean with ajax powder(an water). Im using flex fletch vanes (lower profile since i needed the extra clearance) with flex bond adhesive. Also using easton super uni nocks instead of the nocks that come with the shafts. Havent had a problem. Slight offet is how ive have them fletched.