what do you guys think of this Spine Tester
07-30-2004 | 02:42 PM
#1
Thread Starter
Giant Nontypical
Joined: Feb 2003
Posts: 7,571
Likes: 0
From:
what do you guys think of this Spine Tester
07-31-2004 | 07:21 AM
#4
Nontypical Buck
Joined: Feb 2003
Posts: 3,058
Likes: 0
From: CT, USA
RE: what do you guys think of this Spine Tester
Yep very cool.
The one we have at our shop, made by the folks who make the ratchet press has a special "hanger" for the weight also so that there is no interference.
Unfortunately, like this home-made model, the one by the Ratchet-lock people is set up to test spine the way wood shafting is..i.e. measured over a 26 inch span. Modern alum and carbons are tested over 28 inches. My shop modified theirs so it would measure to AMO/ATA specs (28")
The one we have at our shop, made by the folks who make the ratchet press has a special "hanger" for the weight also so that there is no interference.
Unfortunately, like this home-made model, the one by the Ratchet-lock people is set up to test spine the way wood shafting is..i.e. measured over a 26 inch span. Modern alum and carbons are tested over 28 inches. My shop modified theirs so it would measure to AMO/ATA specs (28")
07-31-2004 | 07:39 AM
#5
Giant Nontypical
Joined: Feb 2003
Posts: 9,175
Likes: 0
RE: what do you guys think of this Spine Tester
The one I've got has the two pound weight on a swinging arm, and the weight sits directly over the indicator. I think I might modify mine to use this guy's idea. Never have been too sure about how much weight I'm actually putting on the shaft the way I've got mine set up.
