Epoxy setting time on Axis arrows?
#11
RE: Epoxy setting time on Axis arrows?
double ceek, also i know that if you put the knocks on before the inserts it can increase the setup time, because there is no moving air. but yeah...I would take them back too.
#12
Thread Starter
Join Date: Feb 2004
Location: Inverness, MS
Posts: 3,982
RE: Epoxy setting time on Axis arrows?
Thanks for the replies guys, I took them back today and was informed that mine were the first they had tried!!! They are going to try them again and I will pick then up next week. Hopefully, everything will be good this time.
#13
RE: Epoxy setting time on Axis arrows?
ORIGINAL: Double Creek
...mine were the first they had tried!!!
...mine were the first they had tried!!!
I agree, it just sounds like they didn't mix it correctly or at all.
They set up in about 12 hours and full cure is 24 hours.