Anyone want to give me the instructions on how to assemble these D!@#m things, slick trick sent me a package of three to try out on the basis if i liked them i payed for them, if not i can send them back but first i have to figure out how to put them together, thats one point against them and a plus for muzzy and thunderhead.Any help appreciated if you have already done this. DEAN

Took me 3 weeks and two fingers to figure out how to put those muzzies together[]

Have you tried reading the instructions?

Take the blade that has the long center slit that is open at the bottem and insert it through one of the slots in the ferrule until its center slit lines up with the the other slot in the ferrule. Then insert the other blade through the other slot in the ferrule and through the center slit in the first blade. Slip the metal washer up over the threads and push the blades forward until they seat firmly in the tip. Screw it on your arrow. Sounds harder than it actually is. I didn' t find the assembly of these to be that difficult.

step one take head and blade with long slit. insert blade into head.

slide blade to top of head.

insert blade with small slit into head. NOTE that this blade is slid all the way to the bottom of the head!

Slide smal slit blade to top of head to finish.
Add washer, and screw into insert
Sorry about the bad pics...just whipped this up.

[Deleted by Admins]

I just got mine today. While my Muzzy' s, Wasp and Thunderheads all shoot fine, these have a slightly larger cutting diameter than my four-blade Muzzys, and fly just as well. The only drawback, they seem to make a lot of noise going to the target. Anyone else experience this?
Charlie