Bear Attack set up?
#1
Spike
Thread Starter
Join Date: Oct 2010
Posts: 1
Bear Attack set up?
I received my Attack yesterday and have already been out in the yard getting getting it set up. I have stripped most of my good equipment off my old bow and now have it on my new. My question is…. With the bow being so quiet do I need to, or should I install my limbsavers on it? Should they be about 2-3” from the ends as with my old bow? Seeing my set up below, do you have any suggestions on my set up? I have nothing on my strings or cable for noise.
This is the current setup:
Limbsavers S coil
Limbsavers Cable guard dampener
Limbsavers Teflon slide
Original Whisker Biscuit
TrueGlo Carbon XS 5 pin
Meta Peep
This is the current setup:
Limbsavers S coil
Limbsavers Cable guard dampener
Limbsavers Teflon slide
Original Whisker Biscuit
TrueGlo Carbon XS 5 pin
Meta Peep
#2
As far as I'm concerned you don't need any string silencers. I don't use them on my Attack. I do have limbsavers on mine, don't know if I need them or not. Owners manual states that not be over 2 inches from the limb cups. Love my Attack, smooth, quiet,& no vibration. Shooting 29" 68 lb. 406 grs. Gold Tip XT Hunter 100 gr. Montecs
Last edited by tcicon; 10-27-2010 at 07:57 PM. Reason: addition