Center shot on '08 Allegiance?
02-18-2009, 05:28 PM
#2
Giant Nontypical
Join Date: Feb 2003
Location: HENDERSON KY USA
Posts: 6,634
RE: Center shot on '08 Allegiance?
I don't know where the BT's like to center at but I always START at 13/16 from the riser and I will never use a lazer for center shot,atleast not one that mounts to the riser.
02-18-2009, 07:46 PM
#3
Giant Nontypical
Join Date: Jun 2007
Location:
Posts: 7,367
RE: Center shot on '08 Allegiance?
Greg, 13/16" will get you going and ready to walk back tune. I don't believe I've ever had to vary off of that over 1/16" on any of my Allegiances. I usually just eyball everything up intially, check with my laser tool, and walk back tune.
Dan
Dan
02-19-2009, 05:26 AM
#4
Nontypical Buck
Join Date: Feb 2003
Location: Central PA
Posts: 2,299
RE: Center shot on '08 Allegiance?
yep, everyone's right. Mine is pretty close to that mark as well. I've always set rests up to be centered on that curved trough in the middle of the shelf. It seems pretty close there to start. Of course arrow spine has a lot to do with it too.
02-19-2009, 05:35 AM
#5
Giant Nontypical
Join Date: Jun 2007
Location:
Posts: 7,367
RE: Center shot on '08 Allegiance?
ORIGINAL: muzzyman88
yep, everyone's right. Mine is pretty close to that mark as well. I've always set rests up to be centered on that curved trough in the middle of the shelf. It seems pretty close there to start. Of course arrow spine has a lot to do with it too.
yep, everyone's right. Mine is pretty close to that mark as well. I've always set rests up to be centered on that curved trough in the middle of the shelf. It seems pretty close there to start. Of course arrow spine has a lot to do with it too.
Dan
02-19-2009, 01:24 PM
#7
Giant Nontypical
Join Date: Feb 2003
Location: HENDERSON KY USA
Posts: 6,634
RE: Center shot on '08 Allegiance?
ORIGINAL: Greg / MO
Todd's right about the 13/16... and you can use a riser-mounted laser with complete confidence on your BowTech because they make the riser straight. [8D]
Todd's right about the 13/16... and you can use a riser-mounted laser with complete confidence on your BowTech because they make the riser straight. [8D]
But is it square.
And is it square at full draw. Ok,I quit,no need in starting this debate again.
02-19-2009, 04:56 PM
#9
Super Moderator
Thread Starter
Join Date: Feb 2003
Location: Southeast Central Illinois USA
Posts: 6,969
RE: Center shot on '08 Allegiance?
I always set centershot with the center. Put an arrow on the rest and look at its tip in reference with the cams.
.
02-20-2009, 06:08 AM
#10
Nontypical Buck
Join Date: Feb 2003
Location: Brampton Ontario Canada
Posts: 1,038
RE: Center shot on '08 Allegiance?
If a Eze Center chot tool isn't available, another easy thing to do is to center your arrow in the center of your 'stabilizer'. This is just a starting point.
When the paper tuning begins, 9 out of ten times your rest position will move off of center shot a tad.
When the paper tuning begins, 9 out of ten times your rest position will move off of center shot a tad.