|
replaced peep tubing and
I had the tubing break on my peep so i put a new peice on tonight and went to shoot and the bow was shooting 6inches low(dead center though).I know the tubing wasnt the exact same length so does that effect the peep alignment? I wasnt expecting it to change since all the tubing does it align it. Any ideas as to why it started grouping low? Nothing else was changed. I moved the sights and its back to shooting fine though
|
RE: replaced peep tubing and
ORIGINAL: Crazyfarmer I had the tubing break on my peep so i put a new peice on tonight and went to shoot and the bow was shooting 6inches low(dead center though).I know the tubing wasnt the exact same length so does that effect the peep alignment? I wasnt expecting it to change since all the tubing does it align it. Any ideas as to why it started grouping low? Nothing else was changed. I moved the sights and its back to shooting fine though |
RE: replaced peep tubing and
Is the peep tied in ? If not and if the tube was short , it could have pulled the the peep up or down , depending on where the other end is anchored .
Get rid of the tube peep .They break at the worst possible times and they are LOUD . |
RE: replaced peep tubing and
I would make sure your peep sight isn't moving. If it were to slide down slightly, it would lower the point of impact.
Another good ideayou may already know about..is once you've fine tuned your setup, take some white out and mark reference points on your sight and rest adjustments. gl |
RE: replaced peep tubing and
thanks for the help.. i found out that my peep slid down a little afterall;)
|
RE: replaced peep tubing and
I always measure the distance from the nock point to the peep and write it in Sharpie on the lower limb. Makes it easy to verify if something's gone funky.
|
| All times are GMT -8. The time now is 10:07 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.