HuntingNet.com Forums - No bow press required

HuntingNet.com Forums (https://www.huntingnet.com/forum/)

- Technical (https://www.huntingnet.com/forum/technical-20/)

- - No bow press required (https://www.huntingnet.com/forum/technical/249295-no-bow-press-required.html)

RE: No bow press required

Quote:

ORIGINAL: bigbulls

Page 4.... Center pivot bows.

http://bowtecharchery.com/downloads/07BowtechOwnersManual.pdf

[align=left]To replace string, cables or install a[/align][align=left]peep sight, back the limb bolt out 5[/align][align=left]turns on one end then alternate to the[/align][align=left]other end, repeating this process until[/align][align=left]the end of the limb bolt is just visible[/align][align=left]in the limb bolt viewing hole in the[/align][align=left]riser (Approx. 3 threads visible). String[/align][align=left]tension will be minimal allowing you[/align]to work on the bow as needed.

2008 manual says the same thing.
http://bowtecharchery.com/downloads/OM_BT08.pdf

Interesting...my manual doesnt have anything about it at all. It is completely missing that whole Center Pivot section.

RE: No bow press required

Thanks, I found the round tag that has the info on it. I did the procedure again today because I needed one more turn to line up my peep. It worked well. I did learn a trick though. Getting the string off was easy putting it back on was a tight fit so with the bow sitting perpendicular on my lap and turning the opposite cam down gave me enought slack to easily put on the other string. Now I am ready to give my Fatherinlaw his Fathers day whoopin'.