Can Someone Use OT2 on my Bow?
11-04-2007 | 06:23 PM
#1
Thread Starter
Nontypical Buck
Joined: Feb 2007
Posts: 1,109
Likes: 0
From: Nashville, Ohio
Can Someone Use OT2 on my Bow?
I have to be doing something wrong in the set-up of my program cuz the Easton st epic 400 is not going to be that weak on my set-up.
Here are my specs:
Reflex Buckskin
34" ATA
30" DL
66#
7.375" Brace Height
ST Epic 400 30.5"
100 gr. point
Blazer vanes
10 gr. peep
8 gr. d-loop
2gr. nock point
The slider bar has its cursor as far as you can go to the weak side that just doesn't seem right.
Here are my specs:
Reflex Buckskin
34" ATA
30" DL
66#
7.375" Brace Height
ST Epic 400 30.5"
100 gr. point
Blazer vanes
10 gr. peep
8 gr. d-loop
2gr. nock point
The slider bar has its cursor as far as you can go to the weak side that just doesn't seem right.
11-04-2007 | 06:28 PM
#2
Giant Nontypical
Joined: Feb 2003
Posts: 6,455
Likes: 0
From: Burleson TX USA
RE: Can Someone Use OT2 on my Bow?
Even without running the numbers I will tell you right now the 400's are way under spined for your set up.
But will run the numbers in Archers advantage anyway.
But will run the numbers in Archers advantage anyway.
