RE: How is my form?
 

will a cheap release from walmart that is shorter work for this season and then after season which is soon could i just buy a better one i already know which one i want just cant get till after season i dont have alot of money to spend.

RE: How is my form?
 

i gotcha bout the arm thing i will work on these things when i get home and i have another release i just thougt about it but it is kinda old, it is shorter, the thing is it has a strap type thing like a back pack strap and when i tighten it it loosens a bit, type it is you hold on to it so i guess i will try using that and i would use that when i put the new picture up and tell me if it is still to long.

RE: How is my form?
 

cool sounds ood...sent yo uthose those pics

RE: How is my form?
 

i got em, here is the pics start with the bottom one first.

RE: How is my form?
 

The release you have can be shortened but you might need a little supervision.


I have done it and it is very simple.The nut at the end needs to be removed and then you can pull the release apart and the rod should be exposed.All you need to do is cut the rod with a hax saw(start with a small amount)and then use a vice and just put a new bend on the end.Then put it back together.

You are definately long on draw.

You need to try to get closer to this.

ALso notice how the knuckle is over the release,much easier to execute a shot without punching.

You will notice I have more palm than the previous picture but I have small hands as you probably do.I can shoot this way with little to no torque.The way pictured is painful to me.But I do rotate my forearm out and you should try to do that.

RE: How is my form?
 

looking better!!! though that extra draw length is not letting you bend that left arm out some

RE: How is my form?
 

Draw length is a bit long. About an inch.

RE: How is my form?
 

Tfoxso can i hold the bow like you if i dont torque it i dont really think i was because i was just putting my fingers there and i wasnt pressing with them on the grip. i really dont feel right when i have a couple other ways.

RE: How is my form?
 

should i just cut off the bent part then re bend it?

RE: How is my form?
 

When and if you cut some off that rod put the nut back on before doing so. The saw makes the starter thread rough. Then remove the nut and then bend the rod. Be careful not to smash the starter thread as it makes it hard to start the nut back on. Might be advisable to file the ragged edge of the saw-cut, too. It's not hard, just a bit tedious.