broadhead flight, slicktricks?
#1
Typical Buck
Thread Starter
Join Date: Dec 2005
Location: LI, New York
Posts: 517
broadhead flight, slicktricks?
Hey all, Im shooting a tribute at 70 lbs 28 in draw. My arrows are 28 ins., 100 grain slictricks. I just fletched up my G/T 75/95 pro hunters with Q/S speed hunter st. and half of a reflective wrap.
I have a few arrows that shoot every where but on the spot. I tried rotating noks and they are still out of wack.
Any suggestions?
Thanks!
I have a few arrows that shoot every where but on the spot. I tried rotating noks and they are still out of wack.
Any suggestions?
Thanks!
#2
Join Date: Jul 2007
Location:
Posts: 67
RE: broadhead flight, slicktricks?
You may a coupleodd ballarrows, which is unfixable...Thats why its always good to shot your hunting arrows to check for stable flight.
Another thing could be that your BH's are not square to the shaft which will cause plaining.... If you can try and spin test your arrows to check for any wobble..if you dont have a spinning block try spinning them by puting the BH in your hand with the arrow vertical. Spinn the arrow with your thumb and middle finger, if you feel any wobble or vibration your arrow is not square.. You can also use the edge of a flat table and roll it..pay attention to your BH to see if it appears to move up and down... A G5 arrow squaring device is good for fixing this or most pro shops should have somehting to fix this...
Another thing could be that your BH's are not square to the shaft which will cause plaining.... If you can try and spin test your arrows to check for any wobble..if you dont have a spinning block try spinning them by puting the BH in your hand with the arrow vertical. Spinn the arrow with your thumb and middle finger, if you feel any wobble or vibration your arrow is not square.. You can also use the edge of a flat table and roll it..pay attention to your BH to see if it appears to move up and down... A G5 arrow squaring device is good for fixing this or most pro shops should have somehting to fix this...