HuntingNet.com Forums

HuntingNet.com Forums (https://www.huntingnet.com/forum/)

- Technical (https://www.huntingnet.com/forum/technical-20/)

- - G5 sight (https://www.huntingnet.com/forum/technical/196608-g5-sight.html)

FOP23

07-05-2007 06:37 PM

G5 sight

I have a G5 sight mounted on my Archery Research AR31 bow. I just switched to carbon arrows and I am currently shooting about an inch low at twenty yards. The problem I have is that I'm out of vertical adjustment on the sight. I have the sight mounted in the lowest set of sight holes on the riser, and the sight cranked to the lowest setting. The second pin is on at twenty, but I can't get the top pin in any suggestions. Should I abandon the top pin or try another modification?

mobow

07-05-2007 06:45 PM

RE: G5 sight

Is that the one you can flip over to gain more room?

FOP23

07-05-2007 06:53 PM

RE: G5 sight

Yeah its already flipped, if I go the other wayI would be further off?

mobow

07-05-2007 07:14 PM

RE: G5 sight

I'm shooting off of memory here, I've only seen one G5 sight, but the pin housing itself could be flipped over, giving like.......3 more inches I believe......If you've already done that......Have you tuned your bow since changing to carbon?? Carbon is smaller diameter, and a rest adjustment may be needed.....Also, if you raiseyour anchor (ksser and/or peep) it will raise your point of impact a bit.....That may or may not be an option for you though...

davepjr71

07-08-2007 07:57 PM

RE: G5 sight

I figured out that my anchor point was messed-up when I had the same problem you do. When I corrected that I've had plenty of adjustment. My problem was the peep was too low and when I moved it up a little problem solved.

Also, if you have the ME model you will want to set-up the adjustable bottom pin first. I made the mistake of ignoring the directions and set-up the top 3 and then found out my 50 yd+ adjustable pin wouldn't go up high enough.

r33h	07-10-2007 12:41 PM

RE: G5 sight

Quote:

ORIGINAL: davepjr71

I figured out that my anchor point was messed-up when I had the same problem you do. When I corrected that I've had plenty of adjustment. My problem was the peep was too low and when I moved it up a little problem solved.

Also, if you have the ME model you will want to set-up the adjustable bottom pin first. I made the mistake of ignoring the directions and set-up the top 3 and then found out my 50 yd+ adjustable pin wouldn't go up high enough.

This was my first thought, too. Your peep may be too low. Try adjusting it a little and see what happens. I had this same problem on my Mathews Outback and I adjusted peep up and things started working better.:)

All times are GMT -8. The time now is 07:30 PM.