Drop away and Blazer issues...
 

I was shooting yesterday and noticed that that the metal part on my Nap drop away 2000 has noticeable marks where my blazers are hitting it. I'm assuming that this is some short of tuning issue, but id like to add that my bow is shooting dead on. Any advice that could help stop this issue would be greatly appreciated. Thanks.

RE: Drop away and Blazer issues...
 

What metal part r you referring to?
The Prongs?

RE: Drop away and Blazer issues...
 

The part which the prongs go into. Sorry for not clarifying.

RE: Drop away and Blazer issues...
 

If it's on the outside where the arrow is pointing I really don't see how that could be a vane hitting it.
None the less, paper tune your bow. That will show any fletching contact right away. Also , check the vanes to see if there are any kind of marks on them. You could also powder test if you don't have access to a paper tuning rack.
I have only seen fletching contact only on the prongs and not on the rest itself.

Do you shoot w/ cock vane down?

RE: Drop away and Blazer issues...
 

if its the part i think your sayin that the blazers are hitting, and its hitting in the center of that piece, are you shooting with the odd vane straight down? If you are i would try flipping the arrow over so the odd is pointing up instead and see how that works. Thats how i shoot my trophy ridge and no problems at all. You may have to adjust your drop speed to get the vanes to clear the prongs but that should work fine.

Jeremy

RE: Drop away and Blazer issues...
 

I shoot blazers also and was having problems with them clearing my QAD Ultra rest. Couldnt shoot cock vane straight up because not enough clearance from my cables, but vanes were hitting the rest when it was completely down. Just goes to show you that reading the directions helps, there was another launcher in the package that is an 1/8 taller and solved the problem. Made me feel pretty dumb for not reading the directions.

RE: Drop away and Blazer issues...
 

I believe that NAP was designed for Cock vane down.
If you flip it around the oyher 2 vanes don't have clearence of the prongs.

RE: Drop away and Blazer issues...
 

Yea i have the cock vane down. The arrow in the picture is just showing the peice i was talking about not where the contact is being made. The contact is being made in the center where the vane would go through the prongs. I agree with archer58. I think the cock arrow is supposed to be down for this model.

I forgot to add that bow is perfectly paper tuned and has a bullet hole when shot through the paper.

RE: Drop away and Blazer issues...
 

Well if you are having contact issues your bow is not "perfectly" tuned. The paper is lying to you. You will either have to adjust the timing of your rest or raise your nocking point so the fletching clears your rest. It clearly is not getting away in time.

The rest should come to the full up position in your last inch of draw, right before you hit the wall. If it is coming up before that it is coming up too soon the rest is in contact with the arrow too long. This would defeat the purpose of having a drop a way.

Rest contact and blazers are a BAD thing. They are so stiff they have no forgiveness at all. If you can't fix it I suggest going to feathers, they can hit stuff and have very little effect on arrow flight.

Paul

RE: Drop away and Blazer issues...
 

No problems here with using the BLAZERS from my RIPCORD reston my SWICHBACK XT