RE: New Rest, kinda freaked out...
 

"no contact" I wish my qad had that capability .

RE: New Rest, kinda freaked out...
 

Not during the off-season......during bowhunting season, absolutely. Besides, you could always make the quick jump back to the old rest if things don't work out.

RE: New Rest, kinda freaked out...
 

This is a new bow and I haven't tuned my APA on it yet, so that doesn't bother me too much. But, for some reason, just the anxiety of trying a new rest and potentially using it full time without knowing if it will hold up through a season gives me the heebie jeebies.

Does anyone have any experience with this particular rest? Pro's/Con's?A very reputable person on AT, Mike Carter, highly recommended them on Bowtechs.

RE: New Rest, kinda freaked out...
 

well i get freaked out anytime that i have to change anything on my bow so now you know that you are not the only one.

RE: New Rest, kinda freaked out...
 

I got alot of contact with my QAD as well.....couldn't shoot plastic vanes, had to shoot feathers which didn't both me. Feathers just don't hold up compared to plastics.

I switched to the Cavalier Avalanche rest and am very pleased with it.

RE: New Rest, kinda freaked out...
 

I had the QAD Pro Series and liked it EXCEPT for contact on plastic vanes. Feathers shot MUCH better. As for tuning, it was easy to adjust.

RE: New Rest, kinda freaked out...
 

One of the first things I do when getting a new bow shooting just right, is to make a jig that allows me to easily remove and replace the rest and start shooting bulleyes on the first shot.

It's simple and doesn't cost anything. I take a small block of wood and cut it into an "L" shape that rests against the riser and arrow shelf. I trim the wood to allow the arrow to rest perfectly in the corner of the "L". I make it slightly large to begin with and then I sand it to a perfect fit. All I need to do, is set the arrow on it (while nocked) and then adjust the rest to where the arrow is.

RE: New Rest, kinda freaked out...
 

Very nice, can you take a picture of your jig to give a visual?

RE: New Rest, kinda freaked out...
 

Muzzyman, I had a QAD Pro rest and loved it until sometimes I started getting "bounceback", where the rest came back up just enough to hit the fletching as it flew by. But other manufacturers have had that same problem. I've heard the QAD LD took care of that issue.

RE: New Rest, kinda freaked out...
 

The LD doesn't bounce back. When the launcher goes down, it kind of sticks by some type of internal mechanism. Hard to explain, but it actually slows the launcher down just before it hits its bottom making it quieter also.

I powder tested and paper tuned last night after mounting it. I did have a little contact with the Blazers, but just rotated cock vane up and it resolved that issue quickly.

I really like the design. One thing I've made up my mind on was total containment. I will not shoot another hunting rest without it being total containment. Especially after using the APA the last couple seasons.

Of the people who used it, did anyone use the football thingy to attach the cord to the down cable?