i hear you say stuff about them being staight but offset, how do you set the jig up like that. i have a browning ftetching jig with a straight clamp

thanks

drhoyt

buy a bitzenburger. just kidding, never messed with a browning jig.

sorry i ment a bohning jig

There is a knob somewhere you can loosen and move the arrow into or away from the clamp. This will give you the offset you are looking for. If you can picture what offset is, you will maybe understand how to attain it...Offset is best described as the fletch running "across" the arrow...So the clamp can't be perfectly in line w/ the shaft.....If that makes sense...

thanks for the info. do you normaly move the arrow setting left or right

thanks

drhoyt

Depends if you want left or right helical. Most prefer right helical. But it really doesn't matter.

if i wanted a right offset would i move the front of the arrow right or left

thanks

drhoyt

For right offset (sorry, I said helical in my previous post, old habit...) I believe you would move the front of the arrow to the left.

Correct mob, the rear of the vane/feather (fletch) will be left of the forward end.

Right Offset will spin the arrow so that the point stays tight...although I used left for years and really didn't notice it. Right or left, still better than straight.

That wasn't advice was it? Just a statement.

I dunno.....sounded like it to me, ya ole softie ya!