bowtech modules?
#1
Thread Starter
Join Date: Oct 2005
Location:
Posts: 105
bowtech modules?
i'm not sure if this is the right forum to be posting this in, but if not im sure i will be corrected. I am looking for a draw lenght module for a bowtech patriot single cam, 2002. My current one is prolly a 30 inch and labled DS3. i need a 28 or so. My local dealer said that they could not get them for me and supposedly even talked to bowtech about this to. they said to try looking on ebay for one. I was wondering if someone on here had an extra one or one from any old bow that i could buy. thanks
[/align]
#4
RE: bowtech modules?
The DS#3 module is for 28" draw and if it doesn't fit you the draw stop pobably isn't set up properly.
With the DS#3 module the draw stop should be set at approx. 7.5 mark.
To properly set the stop you'll start by counting up from the bottom (L) end of the cam to the middle of the draw stop screw head.
With the DS#3 module the draw stop should be set at approx. 7.5 mark.
To properly set the stop you'll start by counting up from the bottom (L) end of the cam to the middle of the draw stop screw head.
#5
Thread Starter
Join Date: Oct 2005
Location:
Posts: 105
RE: bowtech modules?
the dummy bow at my archery shop read 28 inch draw and the eguation to figuire it out said 28, but the module that is on my bow, i can get it to fit by using the draw stop, but when i am at the correct lenght, i am sitting right on the hump of the cam so i would like to go a little shorter to give me a let off and a little adjustment.
[/align]