RE: Bullet Removers
 

Go to Sears.....buy a fencing tool called a pinchers....it cuts wire nicely..... put a round in the press and raise it until the pinchers can hold the bullet and pull the case back in the press.....whammo the bullet is removed.....the bullet may be destroyed but it might not make a difference either.....depends on how many you want to pull.....also check Forester for a fantastic bullet puller.....I'd scrap those kinetic hammers.....they scare the hell out of me!@!!

RE: Bullet Removers
 

WThunter,thats why all of us post here! If you don't know ASK...<img src=icon_smile_big.gif border=0 align=middle>

Hunt Safe!

Jack

RE: Bullet Removers
 

A tip ! To keep from hurting the tip of you bullets,your are pounding out,place a half a piece of paper towel[balled up] in the discharge end of the remover. It will get powder on it,but you can shake it out. This will cushion the bullet tip,instead of banging off the hard plastic chamber .

Mounting Man/in PA.

[Deleted]
 

[Deleted by Admins]

RE: Bullet Removers
 

Another tip. If you are pulling bullets from military ammo, or ammo that has the bullet crimped, or very old ammo where the bullet has &quot;fused&quot; to the inside of the case neck, use a seating die and push the bullet back INTO the case a fraction of an inch, to break it loose from the case mouth before putting it into the hammer. This makes it a lot easier for the bullet to slide out of the case.

Keep yore powder dry!!

RE: Bullet Removers
 

good tip elldeguello .

RE: Bullet Removers
 

I just wanted to say thanks for all the help. I finally had a chance to use my bullet remover and it worked great. Now that I know how to use it; thanks to you guys. Thanks again.