870 bead
02-03-2019, 12:37 PM
#1
Spike
Thread Starter
Join Date: Oct 2018
Posts: 3
870 bead
i have an old 870 Wingmaster with a 30 inch plain barrel non ventilated. I broke the bead sight off of it somehow. Anyone have any do it yourself ideas on making a bead on the barrel? Any help would be appreciated.
02-07-2019, 10:26 AM
#2
Nontypical Buck
Join Date: Feb 2003
Location: Waipahu HI USA
Posts: 2,915
There are several fiber optic sights available, for a quick and easy solution. Make sure to check the width of your rib on the barrel. HiViz and TruGlo are 2 companies that come to mind.
If you're set on getting another bead, checkout Brownells for an 870 replacement. You have 2 options there...drill & tap another hole for the new bead, or back out the snapped off screw-base from the bead that broke. These are not impossible as DIY projects, but a gunsmith could do it fast(er).
Good luck
If you're set on getting another bead, checkout Brownells for an 870 replacement. You have 2 options there...drill & tap another hole for the new bead, or back out the snapped off screw-base from the bead that broke. These are not impossible as DIY projects, but a gunsmith could do it fast(er).
Good luck
Last edited by JoeA; 02-07-2019 at 10:33 AM. Reason: typo
02-19-2019, 07:58 AM
#3
Boone & Crockett
Join Date: Jan 2004
Location: Eastern PA
Posts: 12,746
Seems to me to be an easy fix. But if you don't have access to a drill press or a very steady hand I wouldn't attempt it. It wouldn't be too difficult to drill a small hole in the center and a tiny easy out to remove the old bead then screw in a new one. But a gunsmith could do this quickly and it shouldn't cost more than a couple bucks.
Another thing you can do is get a low profile fiber optic sight and epoxy it to the barrel. A good quality epoxy will hold the sight on forever.
Another thing you can do is get a low profile fiber optic sight and epoxy it to the barrel. A good quality epoxy will hold the sight on forever.
Last edited by bronko22000; 02-19-2019 at 08:01 AM.
