Spent shells stuck in H&R rifle.
02-22-2005 | 01:48 PM
#11
Thread Starter
Joined: Nov 2004
Posts: 100
Likes: 0
From: Northern Georgia
RE: Spent shells stuck in H&R rifle.
Well I appreciate the replies, apparently that mistake of putting a thin layer of oil in there probably caused it. Anyhow soon as I get home I'm gonna get it all cleaned out again, and really clean the chamber up. Once again, thanks for the help.
02-22-2005 | 05:05 PM
#12
Boone & Crockett
Joined: Feb 2003
Posts: 11,474
Likes: 0
From: Wall SD USA & Jamestown ND
RE: Spent shells stuck in H&R rifle.
I used to clean my Handi rifles then set them aside. When I went to use them again the chamber was always full of oil. I finally relaized that the oil I always put in the bor would run down into the chamber. However with the handi there is no place for the oil to go except to run back down the barrel when I picked them up again. However that would always leave the chamber coated with oil. Then my brass would stick. Even unfired brass. The same thing will happen if your OLC is to long.
02-22-2005 | 06:02 PM
#13
Joined: May 2003
Posts: 198
Likes: 0
From:
RE: Spent shells stuck in H&R rifle.
You did not say what caliber your rifle is, or I did not catch it but if it is a .223 then the military 5.56 ammo will cause the problem you are talking about. I do not know why but years back they even mentiontd this in the instructions that came with the rifle.
02-23-2005 | 08:29 AM
#14
Giant Nontypical
Joined: Feb 2003
Posts: 6,270
Likes: 0
From: Texas - BUT NOW in Madison County, NY
RE: Spent shells stuck in H&R rifle.
ORIGINAL: Mike01
Well, I had heard of this problem before, where occasionally shells will get stuck in the chamber after firing and must be pryed out. Sorta thought I was on a roll, I had put about 70 or so shells through this new gun, when today the shell wouldn't come out. I tried using my pocket knife and then a screw driver to no avail. Finally would up sticking a thin steel road down the barrel and gently tapping it out.
Well the very next shot the same thing happened, so I went back home. Now the only thing different I've did before shooting this particular day was leave a thing layer of gun oil in the chamber. Could that honestly be affecting it in some way? I took it all apart, wiped everything down and am currently letting it dry.
Just curious if some of ya'll had this same problem and what ya did to fix it, as I really had putting that rod down my barrel through the muzzle and whatnot. It's a Harrington/richardson Ultra hunter in .243.
Well, I had heard of this problem before, where occasionally shells will get stuck in the chamber after firing and must be pryed out. Sorta thought I was on a roll, I had put about 70 or so shells through this new gun, when today the shell wouldn't come out. I tried using my pocket knife and then a screw driver to no avail. Finally would up sticking a thin steel road down the barrel and gently tapping it out.
Well the very next shot the same thing happened, so I went back home. Now the only thing different I've did before shooting this particular day was leave a thing layer of gun oil in the chamber. Could that honestly be affecting it in some way? I took it all apart, wiped everything down and am currently letting it dry.
Just curious if some of ya'll had this same problem and what ya did to fix it, as I really had putting that rod down my barrel through the muzzle and whatnot. It's a Harrington/richardson Ultra hunter in .243.
