mod 70 wincester
 

To remove the barrel and action I just took the two screws out of the bottom of the stock, one was midway up the for arm and the other was behind the trigger guard. the barrel still will not come out of the stock. Is there anything else I need to do? Oh. it is a pre 64 if that makes any difference and it was steel bedded when I purchased it. Thank you for any help.

They are usually pretty difficult once bedded. You kinda have to "see-saw" it slightly, very slightly to get it apart. Hopefully whoever bedded it used some kind of release agent. It also could have worked its way around the action when it was done, making it permanent.

Thank you Sir, I think I will take it to the gun smith I purchased it from and let him show me. Thanks again.

The one I have, 375 H&H has 4 screws. 1 ta rear of trigger guard, 1 in front of trigger guard, 1 in front of the floor plate and a smaller screw about half way up the fore end. Bet you missed a screw or two. The one in front of the trigger guard isn't vissible untill the floor plate is opened.

Here is a link to a not so great schematic but if you print it out it might be usefull. http://www.e-gunparts.com/schemzoom2...re64_schem.jpg It shows 4 screws attaching the receiver, and barrel.