Bases for a Weatherby
 

Well my little prize finally arrived at the shop. Flat out GORGEOUS Weatherby MarkXXII in .22LR. Sure enough, German made by Anschutz, who apparently makes such a good rifle I cannot even spell it correctly. The test target was shot at 55 meters (whatever a meter is...) and was 5 shots tucked nicely into a four leaf clover (appropriate) just under 1/2". With me shooting it, it will likely never shoot such a group again... but at least its got the raw talent.

The receiver is groved for your run of the mill latch on rimfire rings. Personally, I think anyone who would put such type rings on such a fine rifle would 'teach his grandmother to suck eggs.

The receiver is also drilled and tapped for bases. I've raped every single base/ring guide I could get my hands on... nothing shown for the Mark XXII. Anybody have a clue who makes a base for it?

OR..... am I being overzealous in my damnation of clamp-on rimfire rings? Any I should consider....

I'm scoping the gun with a Leupold... Either a 4x28 or 2-7x32..... I can't make my mind up. Help.

RE: Bases for a Weatherby
 

Just a suggestion. Why don't you give the folks at Conetrol a call? Maybe they can help.

RE: Bases for a Weatherby
 

i run into the same problem with a Marlin bolt action .22 lr i got for christmas. i ended up having to order the bases from the manufacurer (Marlin) on their website.

RE: Bases for a Weatherby
 

I would put Talleys on it and maybe Weatherby is selling Talleys rebadged already. Sorry about the Leupold:D

RE: Bases for a Weatherby
 

I just went thru this with my Marlin 22 magnum that I bought. I end up going with Millet rings to the dovetail. No problems so far anyway.

RE: Bases for a Weatherby
 

I've never heard of them? Where are the located?

RE: Bases for a Weatherby
 

Midway listed Talleys as THE bast for Mark XXIIs and they are sold out and back ordered.

Why are you sorry about the Leupold? What would you suggest? Lay it on me.... I'm open to suggestions.

RE: Bases for a Weatherby
 

There is a guy over on 24hour that has them on his rifle . I pasted this here without his permission so that is probably a Capital offense :DOnly kidding about the Leupold a nice gun like that needs a trim little scope like a Leupold that is unless you spring for a 2-7x36 Kahles ;)Buy your talley stuff directly from Talley I am willing to bet they are in stock there I can't stand Midwayusa and that is SOP with me.

RE: Bases for a Weatherby
 

Conetrol's website is www.conetrol.com They are high end, top quality mounts.

RE: Bases for a Weatherby
 

Millett makes an engraved ring that looks great on a Weatherby. Redfield also made a set of engraved rings that have the screws on the underside that were also very good looking rings. If you search around you might find a set of these. I have these rings on my Kimber's, and they are by far the best looking rings. Tom.