aftershockarchery broadhead?
#5
Joined: Nov 2003
Posts: 423
Likes: 0
From: Yorkville, IL
I have not seen a company that has not said that their broadheads were the best, but they have nothing to back that up, yet! They are new, and they will get a lot of skepticism, and all, but you can't say anything about them, but I would like to go beyond that and say, they look horrible, I don't like the concept of their blades, or mechanism to open them! We will find out over time!
#6
I don't think this broadhead will work out very well inless you get a pass through you have a very small entrance wound, heck the thind doesn't even open until it is through the hide of the animal. I don't even think 5shot will waste his time on this one.
#7
Nontypical Buck
Joined: Feb 2003
Posts: 2,978
Likes: 0
From: Vinton VA
I have not seen it, and like Antler I will reserve judgment until I test them myself. I have learned over the last few years not to judge a broadhead by it's looks. I have been suprised many times in the past.
#8
Joined: Sep 2003
Posts: 83
Likes: 0
From:
PA Hardwoods please read all the info before hammering this broadhead.
it is NEW for 2004, the fact that your statement " wound " shows you did not take the time to "learn"(to gain knowledge) about the broadhead. It is not a copy cat, and I dont think we can judge it on past bad performers.
Frequently Asked Questions
- Simply click the questions below to reveal the answers, and click again to close them. -
Q: Will the entrance hole be small or big?
A: The entrance hole will be around a 1 inch slice (about the size of other broadheads in the full open position) and then deploy and expand to a HUGE 2 ¾ inch cutting width (over 2 1/8” for the 100 grain).
www.aftershockarchery.com
PS not hammering on you but take your time to judge
it is NEW for 2004, the fact that your statement " wound " shows you did not take the time to "learn"(to gain knowledge) about the broadhead. It is not a copy cat, and I dont think we can judge it on past bad performers.
Frequently Asked Questions
- Simply click the questions below to reveal the answers, and click again to close them. -
Q: Will the entrance hole be small or big?
A: The entrance hole will be around a 1 inch slice (about the size of other broadheads in the full open position) and then deploy and expand to a HUGE 2 ¾ inch cutting width (over 2 1/8” for the 100 grain).
www.aftershockarchery.com
PS not hammering on you but take your time to judge
Thread
Thread Starter
Forum
Replies
Last Post
8pt~Bowhunter
Technical
7
11-02-2007 03:33 AM
8pt~Bowhunter
Bowhunting
1
10-31-2007 03:51 PM
5 shot
Bowhunting Gear Review
8
03-26-2007 05:38 PM




