From this photo what draw length would you think this bow is set? For some reason I was told 29 inches but I think it is less? Anybody care to help me out.........

You have to look at the module on the other side of the cam and that combined with the post setting (1-10) will tell you the draw length.

If the module is a #2 then it is 29" because it is on post setting 7.

http://www.diamondarchery.com/downlo...08_ModPost.pdf

Is it a number or a setting?

The module will say for example DP2.

The post setting is set by counting the number of tick marks starting at 1 obviously. If you count, your draw stop is on the 7th tick mark.

So if you have DP2 on your module, with the draw stop set where it is, you should be at 29".

Exactly. Look on the other side of the cam for the DP# for draw length, the post setting is for let off.

Does this help

So after posting and looking at your responses than I am at 29. Thanks for your help........gotta get another inch!

Yep.

Like rob said the post setting sets letoff. With your DP2 module and draw stop setting of 7 you should be close to 29". From there you can make small adjustments (Very small) to the draw stop to increase/decrease letoff and make small DL adjustments.

If it feels short your string or cable lengths may be out of whack causing the DL to be off. Best way to check is to measure the actual DL at a bow shop so that you can be sure that all is well.

Thanks,I just got the bow not even a week ago and it just doesnt seem right with the DL. I will be heading to the bow shop this weekend. Thanks for all your help and increasing my knowledge......Rob Donahue