Un-welcome noise!!
 

When I'm not shooting as much as earlier in the season I like to just draw and ease off on my bow several times a dayto keep my muscles in tune. I just noticed a faint little noise coming fromthe top cam of my Vectrix when I ease it off. It doesn't do this on the draw.THIS IS NOT ACCEPTABLE!!! Especially when I'm going to Alberta next week! Any thoughts on what to use (that doesn't smell)to make itgo away?
You never know when you might have to ease off if the proper shot doesn'tpresent itself. It alreadyhappened to me just this season. Any help is appreciated.

RE: Un-welcome noise!!
 

I wouldnt do anything bring it to your shop and have them look at it. you use anything not approved by HOYT will void warranty

RE: Un-welcome noise!!
 

I agree get it to a pro shop. They will tear the top cam off and check the bearings. They have scentless oil that they will put on it if they cannot find anything wrong. Also check the screws in the cam and make sure one hasn't backed off and is rubbing something. Good luck in Alberta!

RE: Un-welcome noise!!
 

Thank yourazor, but there aren't any screws. The cam is on a shaft with spacersand clips on the ends.

RE: Un-welcome noise!!
 

Sounds your bearing might be shot. Im not sure But i think its becase your drawing slowly and letting down a little slower...But i think your bearing is bad....bring it to the shop had that on my old magnatec and my bearing had gone bad.

RE: Un-welcome noise!!
 

If the bearing was shot wouldn't it make noise on the draw as well? This is an '07 Vectrix XL with, I'm guessing, maybe 1000 shots fired from it. Also, wouldn't you get some cam lean (which I don't have)from shot bearings?I was hunting in the rain a little bit lately. Perhaps this could have something to do with it.

RE: Un-welcome noise!!
 

could be but i didnt get cam lean with bad bearing when the bearing is moving slower it might not make a noise. The fast the bearing moves the more noise it makes could be...not saying it is just a suggestion....sounds like a bearing thats all...

RE: Un-welcome noise!!
 

I know that there are no screws on the actual axle, but the cam itself does.

RE: Un-welcome noise!!
 

Not to be arguementitive, but no it doesn't.;):D:D:D Any other ideas guys?

RE: Un-welcome noise!!
 

I would try an approved lubricant before I took anything apart this close to your trip. With 1000 shots, the bearing is not really suspect. This would be like the wheel falling off a car on the way home from the dealership. Just needs alittle TLC after the wet hunting trips.

Which cam do you have? From the manual:


ECCENTRIC LUBRICATION

Cam & 1/2 Performance System bows (except for Versa Cam & 1/2) feature sealed ball bearings which do not require lubrication.
For conventional bearings or bushings, such as those found on AccuWheel and Versa Cam & 1/2, a light spot lubrication of the axles where they pass through the eccentric should be done on a regular basis (1,500 - 2,000 shots). In adverse hunting conditions where dirt, dust or moisture are encountered, lubrication may be done on a daily basis. Hoyt recommends you use a silicone or Teflon based lubrication or any other quality grease available at your local Hoyt Pro Shop. It is NOT recommended that you use "Penetrating Oils" such as WD-40, EZ-#7, Fast Break, etc.