RE: Field Point vs. Broadhead flight/grouping problem
 

Ah ha! sounds like you found your culprit, or at least a major factor. I never did like those EZ Fletchers. This will likely solve the group size issue but the point of impact of the group is still going to be a tuning issue with the bow. You should read the Easton tuning guide or at least the broadhead tuning section of it.

RE: Field Point vs. Broadhead flight/grouping problem
 

I don't know how you figure that, but whatever. Shooting low or high is no different than shooting left or right. Something is off. Why would someone go thru the trouble to tune their bow for bh's hitting left or right, but not up or down? Also not sure what centershot has to do with a broadhead hitting low or high either. As far as nock pt adjustment...I can adjust mine in a matter of maybe 5 seconds. Not sure what is involved with yours, but I simply get the nock pliers out, loosen, move, tighten.

RE: Field Point vs. Broadhead flight/grouping problem
 

Agree completely. The tuning guide oughta be required reading with a test for anyone that wants to bowhunt. It is simply invaluable, IMO. I do like the EZ fletcher though...I have been using the same one for the last 19 or so years, even though I have the original (for aluminums) it works fine for carbons, just gotta be careful closing it.

RE: Field Point vs. Broadhead flight/grouping problem
 

And all I said was it could be as simple as a sight adjustment.

They wouldn't. I never addressed those issues.

I mentioned checking center shot when you touted moving the rest and nocking point as a "fix" for hitting low. Assuming center shot and spineare correct.....you need to adjust your sight. Period. Center shot, first. Sight adjustment last. I would never adjust my nocking point without checking center shot/level....and simply hitting low wouldn't tell me the nock set or rest was "off", necessarily. I'd also ALWAYS adjust rest height first (before nocking point) if it were feasible.

I don't use a brass nocking point, either. But I'd still ask you why you wouldn't simply adjust your rest height. For me....(and I have to assume you don't shoot a D-loop)...."I'd" have to remove the servedin nock sets I have above and below my nocking point. Remove my D-loop. Tie in a new upper and lower nocking point....and tie on a new D-loop. I'd rather simply adjust my rest height if it's feasible to do so.

RE: Field Point vs. Broadhead flight/grouping problem
 

If you say so...

The guy's broadheads are hitting low as compared to fp's. He needs to adjust his rest or nock pt - if it was me, that is what I would do - period. I would never adjust my sight in his situation. According to your statement in bold above,someone's set uphypothetically couldbe a half inch or more nock high and you are saying adjust your sight "period". I guess if it works for you, then go with it.

Yes, the reason I would go for nock pt first is cause I do not shoot a loop.

RE: Field Point vs. Broadhead flight/grouping problem
 

I consider "level" an aspect of "center shot"....and even said so.

So....I stand by the bolded statement.

RE: Field Point vs. Broadhead flight/grouping problem
 

Ihad the same problem...Muzzys were ok..but Steel Force closed the group..They shoot so good that I only shoot one at a time..tired of rippping up fletching.
They are 3 for 30.00 :(..but worth it..

RE: Field Point vs. Broadhead flight/grouping problem
 

I guess now I know why I was having such a hard time getting why you would say what you were saying....kind of.