Loop question
 

For those hunters who use a loop. How long is your loop?

I was thinking 1/2 inch, is that enough?

RE: Loop question
 

All personal preference Gary.....

You just have to make sure your calipers will fit in there with your nocks.

I like mine very short......but that's probably been attributable to me shooting too long a DL.

RE: Loop question
 

About 3/4 on mine, I could go shorter on some nocks but it'sbetter forclearanceon my hunting arrows.

RE: Loop question
 

mine might be just a bit shorter but when cutting the loop string make sure u cut it 4 1/2 inches for a 1/2 inch loop. Burn each end and put string wax on it so it will set in place. youll have some extra once you get your loop tied but you need it while tieing. just cut it off and burn that end again. kinda pull it with your relese to make sure it snugs up.

RE: Loop question
 

Mine is as small as I can make it without interfering with the arrow nock.

RE: Loop question
 

as short as i can get it and still get the caliper on it.

RE: Loop question
 

As other said, as short as you can make it, about 1/2". It depends on how deep your nocks are a bit also. It is stiff using old bow string so attaching the release w/o looking is not a problem

RE: Loop question
 

I consider my draw length when making mine. I have 29 inch draw. My bow is set at 28 1/2 so I use a 1/2 inch loop. If your bow is set at your draw length and you add a 1/2 inch your over drawn.

RE: Loop question
 

Mowtown that is exactly why I am asking

I am 28'' draw and I would go to 27.5

RE: Loop question
 

Loop? What's that?;)

My bows don't have them[8D]

Dan