checking for fletching clearance
 

i was wondering of a good way to check fletching clearance i know when i nocked an arrow withthe cock feather down it hit my rise because it left a film or somthing on it,,have turn cock vane out since but think that arrow is hitting the sight self holder thing that hold my arrow for my qt2000 dropaway and not entirely sure that vane are clearing dropawy and suggestions??[/align]

RE: checking for fletching clearance
 

You can put lipstick on your rest and see if it ends up on the vanes. I haven't had good luck with that method. Spray foot poweder on the vanes and shoot them. You will see exactly where the vane is hitting.

RE: checking for fletching clearance
 

Feathers or vanes? If you are using vanes a good indicator is that the vane will wrinkle after several shots. The lipstick suggestion is good, foot powder works also.

RE: checking for fletching clearance
 

that is how i figured out my vanes were hitting the riser in a cock vane down postision espesally with the qs vanes they did not last long

RE: checking for fletching clearance
 

Cock vane up. I use a Drop Zone, and that's how I shoot. Also, make sure the timing of the rest is right. If it drops too late, it hasn't fallen out of the way by the time the vanes get there.

RE: checking for fletching clearance
 

my vanes were hitting therisser when i had the cock vane down,,if i move it up it would cause the other side to hit would it not,, but with the cock vane out it hits the arrow holder for the qt2000 which sets on the sight self

RE: checking for fletching clearance
 

If your vanes are actually hitting the riser, I would suspect your problem to be more like the rest not being installed properly.If you have the means to post a pic that would be helpful.

RE: checking for fletching clearance
 

i will try to get a picture next tuesday or wednsday otay??

RE: checking for fletching clearance
 

That's what it sounds like to me. I just helped a friend last night with the same problem, we moved the rest away from the riser, paper tuned and he just called me coming from the range and re-siteing in and saidall is well except his arrows are under spined which is the same thing I told him. We used my old arrows by the way for him to paper tune with.

RE: checking for fletching clearance
 

if u move the rest over that take it out of center,,would this matter??