Rage Broadhead Problem!!
09-09-2008 | 10:11 AM
#1
Thread Starter
Spike
Joined: Jul 2007
Posts: 47
Likes: 0
From:
Rage Broadhead Problem!!
Has anyone else had a problem with the rage broadheads opening while during a stalk or when you put them in the quiver. I love the way they fly and the damage they do, but last year the blades were always falling out and i was having to mess with them all the time. Any Suggestions or am I the only one with this problem?
09-09-2008 | 12:24 PM
#3
Fork Horn
Joined: Dec 2006
Posts: 220
Likes: 0
RE: Rage Broadhead Problem!!
ORIGINAL: GrtWhtHntr
Has anyone else had a problem with the rage broadheads opening while during a stalk or when you put them in the quiver. I love the way they fly and the damage they do, but last year the blades were always falling out and i was having to mess with them all the time. Any Suggestions or am I the only one with this problem?
Has anyone else had a problem with the rage broadheads opening while during a stalk or when you put them in the quiver. I love the way they fly and the damage they do, but last year the blades were always falling out and i was having to mess with them all the time. Any Suggestions or am I the only one with this problem?
09-09-2008 | 07:41 PM
#5
Nontypical Buck
Joined: Nov 2005
Posts: 3,399
Likes: 0
From: Mn.
RE: Rage Broadhead Problem!!
Yep....Mathews T5.....
Grt......You can take a old fixed blade Broadhead and heat it up and push it into the foam,do it once all the way in then turn the broadhead and go 1/2 way down,this will give you a place for fixed and mech BHs..
Depending on quiver you should get 3-5 nice BH holders in the foam.........
Grt......You can take a old fixed blade Broadhead and heat it up and push it into the foam,do it once all the way in then turn the broadhead and go 1/2 way down,this will give you a place for fixed and mech BHs..
Depending on quiver you should get 3-5 nice BH holders in the foam.........
09-10-2008 | 04:56 PM
#8
Nontypical Buck
Joined: Jun 2007
Posts: 2,546
Likes: 0
From: Camden,MO
RE: Rage Broadhead Problem!!
what i have found is that the problem is that most people dont check the o-ring and make sure that the blade is all the way in place. I was afraid of them to but then i did and i'm glad i did. they just aren't for some people.
....
09-10-2008 | 06:35 PM
#10
Fork Horn
Joined: Apr 2008
Posts: 111
Likes: 0
From: ALLEGHENY CO. PA
RE: Rage Broadhead Problem!!
I had that problem just turn your O ring a little bit and you will be fine. Just remember when you shoot something check the O ring if it is cut or damanged change it. I shot 2 doe with the same blades and sameO ring last year. Just washed the blades off , and turned the ring a little ,they locked just fine.
