arrow saw
 

Ok, I made me a simple and effective arrow cutter.
I just had a metal bar glued to a board and made a small cut for the dremel disk, I put a screw next to the metal gliding bar to prevent the dremel from cutting all the way.
Easy, just test an old arrow several times and make sure your disk sits square in the end of your dremel.
I have now the one and only combo, arrow cutter and spinner tool...
pics can be found here;
http://www.flickr.com/photos/69041177@N00/sets/72157601234372217/

thx for the help, Dave, Josh and Jamaltwy....

F.

RE: arrow saw
 

That's pretty slick Frank. Do you have closer pictures and different angles of how you connected the dremel shaft? You can just email tehm to me if you could. Thanks.

RE: arrow saw
 

Hey that look good. I bet it didn't cost much either. Sweet Rig:).

RE: arrow saw
 

the spinner plus the saw cost me a total of approx. 60 dollars....
cheap and it works.....

F.