Got another opportunity today to get some shooting in. All had to do was to dodge or time the expected rain storms that were to occur today + plus I needed to be back in town by 3:30 for the Gonzaga basketball game.


My excuse for this trip was actual bullet testing... Lehigh brought a new bullet out late last year. I got to shoot it enough to site the rifle in with it and then I really wanted to harvest a whitetail with it to compare it to the Bloodline. Did not get a chance to use the bullet because I got to choosey looking for the RIGHT buck.


But, the bullet is a copper .452x265 gr. with a the open nose hollow point.







Also last fall while shooting through a chrono I did establish the velocity I was shooting





To me this is a really good looking CNC machined bullet. My early and first testing of the bullet showed that it was really and accurate bullet from Knight Ulite. The accuracy is there + plus I got a bit lucky.





Today my mission in my mind was to reshoot this bullet and see if I could feel as good about it today as I did last fall.


It rained on me most of the way to the rock pit but by the time I got to the pit the rain had stopped. I quickly got the shooting bench and tailgate setup. Then in the back of my mind... I had been shooting so well with the fast twist 45's - really shooting clays @ 100 just didn't seem to be a challenge any longer. It worked out because there were plenty of chips on the rock wall in various spots. I got loaded as quickly as possible and started my experiment.


This rifle as the others I shoot have been setup with a 6" PBR and back when I set the rifle up I set to be just under 3" high at 100.


This ballistic print out shows the information computed from last fall.





I set up on the first chip... @ 100 yards I have found that just above the main cross hairs at the beginning of the thickened vertical post conforms to 0 at 100. So I placed the vertical post on the ship and took the shot. After the smoke cleared - the chip was gone. That provided a huge ego boost and a great reason to continue the shoot.


I continued the shoot till the rain started and washed me out of the pit. And I have to tell you I feel that I made some really difficult chip shots. The bullet just seems to be consistent as heck even though I am using a volume measure for loading.

That's the one nice thing about "one ragged hole" = it speaks for itself.

Actually says something about the shooter !!!

That is awesome shooting there Sabot. I need to find me a place where I can shoot more than 100 yards and try to extend my ML range. The only place I know right now gets weeds 4' tall and its too rough to run a mower down and I don't have access to a brush hog.
I'm pretty sure when I find a place that Lehighs will likely be on my list of bullets to test.