Thinking of a project
12-27-2015 | 02:33 PM
#11
Thread Starter
Boone & Crockett
Joined: Jan 2004
Posts: 12,823
Likes: 5
From: Eastern PA
12-27-2015 | 02:45 PM
#12
Giant Nontypical
Joined: Feb 2011
Posts: 9,557
Likes: 0
From: Colorado
Oh, I forgot. Is this for a TC? The way I understand it GM stopped making the drop in barrels for the TC guns, because they couldn't get the breech plugs for TC anymore.
TC sure let a lot of people down by dropping their sidelocks.
TC sure let a lot of people down by dropping their sidelocks.
12-28-2015 | 04:08 PM
#13
Banned
Joined: Oct 2015
Posts: 146
Likes: 0
Another stupid Bob idea
I will first do a trial fit for sure. But then I was thinking, I will likely have to work either the barrel or the breech depending on where the mis-alignment is. I have to keep the sights on top and the vent liner on the right side.
Neither barrel will be orphaned. I am going to switch breech plugs.
Neither barrel will be orphaned. I am going to switch breech plugs.
I was going to say, make me an offer and I'll buy the 1-28 from you. Dumb idea, I need a project right now like I need another hole in my head. However, I'd bet there's a whole mob of people who would love to have a nice conical barrel. Feed it Hornady Great Plains bullets and enjoy. You know I'm not big on roundball barrels, but they're as common as sin on Saturday night. You could buy one, and make someone else the very happy new owner of a nice conical shooter. I bet you thought about this already.
OldBob
