![]() |
Knight Breech Plugs/Conversion Kits
Does anyone know where I can get a conversion kit or just the breech plug for a 50 cal Knight Wolverine? I would like to find the original 209 conversion type not the new extreme that uses the plastic disc., any help is appreciated.
|
Originally Posted by redmag
(Post 4065872)
Does anyone know where I can get a conversion kit or just the breech plug for a 50 cal Knight Wolverine? I would like to find the original 209 conversion type not the new extreme that uses the plastic disc., any help is appreciated.
This the Red FPJ breech plug http://www.knightrifles.com/breech-plug-M900021/ They no longer show the bare primer breech plug. I think the safety liability of shooting a bare primer in an open breech rifle may be a factor. |
I do not want to use the orange plastic disc but just the breech plug where the primer is inserted into the plug. I have one but it became too tight after one shot to removed the fired primer and an unfired primer would not go in. In my wisdom I took it to a gunsmith and had it reamed out slightly. Unfortunately, now the primer will fall out if I am not careful.
Thanks |
The bare 209 primer part number was Mfg# 900045 for the BH, W209 and TK2000
http://www.knightrifles.com/pdfs/2010_Acc_Catalog.pdf Good luck |
Originally Posted by redmag
(Post 4065899)
I do not want to use the orange plastic disc but just the breech plug where the primer is inserted into the plug. I have one but it became too tight after one shot to removed the fired primer and an unfired primer would not go in. In my wisdom I took it to a gunsmith and had it reamed out slightly. Unfortunately, now the primer will fall out if I am not careful.
Thanks I believe the part number you are after is #M900045. |
I did a quick search and could not find any for sale. They turn up on the auction sites sometimes.
|
I have looked for sites that sell them and cannot find any in stock. Guess I will just continue with my old one and rig something to make sure I don't lose the primer. It is a PIA to keep looking to make certain the disc is there. Thanks for the replies.
|
Originally Posted by redmag
(Post 4066048)
I have looked for sites that sell them and cannot find any in stock. Guess I will just continue with my old one and rig something to make sure I don't lose the primer. It is a PIA to keep looking to make certain the disc is there. Thanks for the replies.
mike |
| All times are GMT -8. The time now is 10:32 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.