Ok...anyone run into the issue with the T/C U-View powder not measuring the same grains of BH209 as the BH209 powder tubes? If I put 90 gr. in the T/C measure, the BH209 powder tubes only measure the same amount at 80 gr. Which one is correct?

I use the Uview and have compared the volume measure to weight and the Uveiw is always dead on per my scales. I would go with the Uview, I have seen many complain about the BH209 tubes.

I also have checked my U-View against the balance scale I weigh my reloads with; my U-View and 4 or 5 others I accumulated over the years. My U-View is with in one grain all the time the way I use it. none of the others are that close, and the tubes are way off and vary considerable.
I have one measure that is so far off I use it to demonstrate why all measures should be checked against a scale, it is actually over 20 gr off. It is an Italian brand since we are not suppose to knock brands I won't say any more than that but it sure makes a point when we have a kids class.
Be careful, SAFTY is always the most important thing.

I also use the U-View....I find it to be right on. Pictured is My Back Up New One still in it's Package. I was Kind of Shocked to see where it was Made being from TC.......So Much for Buy American Made, Made By TC
(BP)
(BP)

Well that is disappointing.

Thx for the input. I will only use the tubes as carriers of the powder load that has been measured with the U-View.

the bh209 tubes are known to throw charges a good 10gr +/- over what it should be.