Got the breech plug measurements
01-01-2011 | 07:33 PM
#1
Thread Starter
Banned
Joined: Dec 2008
Posts: 9,186
Likes: 0
From: Boncarbo,Colorado
Got the breech plug measurements
I haven't been shooting a whole lot lately due to being out of ammo and with the Holiday's it really took a bite out of shooting.
But tonight i was itching for something to do, so i got the CVA Accura V2 out and took a bunch of pictures. Well while in the process i decided to go a head and tighten up the Firing Pin Bushing a bit with Two layers of White teflon Tape around it. Reinstalled it snug, then backed off and started fiddling around with the right primer fit.
In the end, i had to back the firing pin bushing out .016" in order to get a slight crush fit with the CCI 209M primers.
Im workin on the pictures now so maybe tomorrow i will get some uploaded.
But tonight i was itching for something to do, so i got the CVA Accura V2 out and took a bunch of pictures. Well while in the process i decided to go a head and tighten up the Firing Pin Bushing a bit with Two layers of White teflon Tape around it. Reinstalled it snug, then backed off and started fiddling around with the right primer fit.
In the end, i had to back the firing pin bushing out .016" in order to get a slight crush fit with the CCI 209M primers.
Im workin on the pictures now so maybe tomorrow i will get some uploaded.
01-02-2011 | 08:07 AM
#2
Giant Nontypical
Joined: Mar 2010
Posts: 5,612
Likes: 0
Is there a reason you cannot use a shim under the bushing like Bellm uses on the T/Cs? I would bet contacting him about it might lead to another option. He has some extremely thin stainless firing pin bushing shims for only $14.95.
http://www.bellmtcs.com/store/item.php?pid=1008&cid=243
2- .005" thick
1- .004"
1- .003"
1- .002"
1- .001"
http://www.bellmtcs.com/store/item.php?pid=1008&cid=243
2- .005" thick
1- .004"
1- .003"
1- .002"
1- .001"
Last edited by Gm54-120; 01-02-2011 at 08:12 AM.
